Author Topic: Apollo 11 Lunar Lander Pre-Launch  (Read 203204 times)

Offline nomuse

  • Jupiter
  • ***
  • Posts: 859
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #240 on: December 18, 2018, 11:41:03 PM »
Hi Alan F

Don't say I don't help you guys. Here is some bedtime reading for you. I have a lot more places to get docs. Happy Reading.

https://www.ibiblio.org/apollo/Documents/

A reminder;

Most of us here have been reading up on Apollo for a decade or more. Some of us work professionally in the aerospace industry. You aren't finding docs none of us have seen or couldn't find on our own.

What you are doing, is explaining what exactly it is you read that gave you the coobadoodly ideas you've been presenting here.

Offline jr Knowing

  • Earth
  • ***
  • Posts: 127
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #241 on: December 18, 2018, 11:44:18 PM »
Hi Von_Smith

You would have to ask NASA. But to be clear, the paper doesn't say they won't work, just that there is significant risk using them. Also what would have been the alternative? You had engines thrusting directly onto the lower part of the LM. That certainly would have raised questions on how that was possible without creating perhaps catastrophic issues for the craft. So stick with the deflectors and hope no one questions it?

Offline jr Knowing

  • Earth
  • ***
  • Posts: 127
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #242 on: December 18, 2018, 11:46:34 PM »
Nomuse,

I was responding to a poster who asked for help.

Offline nomuse

  • Jupiter
  • ***
  • Posts: 859
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #243 on: December 18, 2018, 11:47:08 PM »

Why would NASA put plume deflectors on Apollo 12, then?  This memo came out three weeks before Apollo 12's launch, meaning that from this point forward the deflectors would no longer serve the purpose of convincing engineers that the missions were legit, right?  Since those same engineers were supposedly now convinced that the deflectors were bad?

Yeah, it's a variation on Jay's "Hire that astronomer, then!"

If a good engineer could see there was something suspicious about the design, then it behooves you to, well, hire a good engineer to design it in the first place.

I'm convinced this is entirely a problem of ego. The average hoax believer is fine with "anomalies" that are so obvious anyone can see them (anyone but paid dis-informants and of course brainwashed sheeple). Some hoax believers, however, aren't satisfied with that. They want "anomalies" that only they personally are smart enough to have noticed.

Offline JayUtah

  • Neptune
  • ****
  • Posts: 3814
    • Clavius
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #244 on: December 18, 2018, 11:49:35 PM »
I was responding to a poster who asked for help.

He was asking for accountability.
"Facts are stubborn things." --John Adams

Offline JayUtah

  • Neptune
  • ****
  • Posts: 3814
    • Clavius
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #245 on: December 18, 2018, 11:53:29 PM »
You would have to ask NASA.

And NASA asks me, because I'm the kind of person NASA would hire if it wanted a working spaceship.  Why won't you listen to me?

Quote
But to be clear, the paper doesn't say they won't work, just that there is significant risk using them.

You're not a competent analyst of risk.  You don't understand the underlying mechanisms.

Quote
So stick with the deflectors and hope no one questions it?

Or stick with the deflectors (which correct a problem with the common case) and address the problems the deflectors raise (which, in your memo, arise only in uncommon cases).
"Facts are stubborn things." --John Adams

Offline JayUtah

  • Neptune
  • ****
  • Posts: 3814
    • Clavius
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #246 on: December 18, 2018, 11:59:58 PM »
I'm convinced this is entirely a problem of ego. The average hoax believer ... wants "anomalies" that only they personally are smart enough to have noticed.

Jr Knowing has gone over fully into ego-reinforcement mode.  Note how most of his posts lately are just crowing about what a great researcher he is, how he has to "help" his critics, and how he's the one who's winning the debate by producing documents.  Incidentally this is where the Internet Keyboard Warriors differ from serious researchers.  They define success by how many links they can produce, not how well they can understand the concepts.  While they frantically Google, I can pretty much teach these concepts from memory.
"Facts are stubborn things." --John Adams

Offline Von_Smith

  • Venus
  • **
  • Posts: 85
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #247 on: December 19, 2018, 12:01:45 AM »
Hi Von_Smith

You would have to ask NASA. But to be clear, the paper doesn't say they won't work, just that there is significant risk using them. Also what would have been the alternative? You had engines thrusting directly onto the lower part of the LM. That certainly would have raised questions on how that was possible without creating perhaps catastrophic issues for the craft. So stick with the deflectors and hope no one questions it?

But that's just it:  according to you, somebody already *had* questioned it.  Your answer makes no sense; why would NASA assume that engineers in the audience would be savvy enough to perceive a need for plume deflectors and at the same time too dumb to work out the stability problems their own engineers had already worked out?  Why not instead fake a new feature that solves both problems?
« Last Edit: December 19, 2018, 12:22:59 AM by Von_Smith »

Offline nomuse

  • Jupiter
  • ***
  • Posts: 859
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #248 on: December 19, 2018, 12:30:16 AM »
Yeah. When I ask someone to explain, when I see a link I wonder if they can think for themselves. When that link is to a video I wonder if they can think.

Offline Jason Thompson

  • Uranus
  • ****
  • Posts: 1601
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #249 on: December 19, 2018, 12:50:13 AM »
The fact is I am the only person who has provided any documentation regarding the workings of the deflectors.

Providing the documentation is one thing. Understanding it is another.

Quote
I find it comical on how everyone has twisted this MIT paper to mean nothing.

Please show us where we have 'twisted' the memo rather than pointing out some pretty significant caveats.

And once again, do you understand the difference between a paper and a memo? This is not trivial.

Quote
And to suggest that these conclusions have no bearing to the LM flying solo (detached from the CSM). If anything, it is even more problematic for the LM operating solo.

The graph in that memo specifically contradicts that assertion.

Quote
Atleast the CSM-LM had the ability of disabling the LM RCS’s if there is a failure or mismatch power issue ( ie one RCS operating at 50 percent of the opposite RCS) and rely on the CSM RCS’s.

No, the stacked vehicle only ever used the RCS on the service module in normal flight. It did not have to 'disable' the LM RCS because they were only intended to be used when the LM was flying solo.

Quote
(That is what happen with Apollo 13, I have the report)

If you have the report how are you making such a fundamental error in fact? On Apollo 13 the CSM was shut down and the LM RCS used to control attitude when required. This is the only time the LM RCS was used to control the stacked vehicle, and it wasn't done by automatic control.

Quote
But with the LM operating alone there is no backup if there is a failure or mismatch of power between two opposite thrusters and that will result in serious stability issues.

No, it won't, for reasons already explained.

"There's this idea that everyone's opinion is equally valid. My arse! Bloke who was a professor of dentistry for forty years does NOT have a debate with some eejit who removes his teeth with string and a door!"  - Dara O'Briain

Offline Jason Thompson

  • Uranus
  • ****
  • Posts: 1601
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #250 on: December 19, 2018, 12:54:07 AM »
Hi Von_Smith

You would have to ask NASA.

No, we're asking you, because you are the one claiming it was a problem.

Quote
But to be clear, the paper doesn't say they won't work, just that there is significant risk using them.

Under a very specific cet of circumstances that are extremely unlikely to occur. It also illustrates how the problem can be avoided by manual crew intervention. If you disagree with that statement then tell us why.

Quote
Also what would have been the alternative? You had engines thrusting directly onto the lower part of the LM.

Once again, prove this was an issue, and address the response you got to your request for an example of any other vehcle that does this kind of thing.

Quote
That certainly would have raised questions on how that was possible without creating perhaps catastrophic issues for the craft.

No, it wouldn't, for reasons already explained in this thread.
"There's this idea that everyone's opinion is equally valid. My arse! Bloke who was a professor of dentistry for forty years does NOT have a debate with some eejit who removes his teeth with string and a door!"  - Dara O'Briain

Offline Jason Thompson

  • Uranus
  • ****
  • Posts: 1601
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #251 on: December 19, 2018, 12:55:20 AM »
Hi Alan F

Don't say I don't help you guys. Here is some bedtime reading for you. I have a lot more places to get docs. Happy Reading.

https://www.ibiblio.org/apollo/Documents/

No, when someone asks you for a specific book you don't point to a library.

If you want honest debate, as you claim, then answer questions properly.
"There's this idea that everyone's opinion is equally valid. My arse! Bloke who was a professor of dentistry for forty years does NOT have a debate with some eejit who removes his teeth with string and a door!"  - Dara O'Briain

Offline onebigmonkey

  • Uranus
  • ****
  • Posts: 1607
  • ALSJ Clown
    • Apollo Hoax Debunked
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #252 on: December 19, 2018, 02:40:06 AM »
Careful jr, your slip's showing. You've subtly shifted to "you may not have looked at these photos properly" to "I know more than you".

You don't.

The paper does not support your position either that there is a problem with the deflectors or that there is an adequate documentation and research on them. Like each of your vaguely hinted at claims, there is no substance here.

Still waiting for you to provide support for the unnecessary side issue you introduced about the fender, and the fact that the photographs I posted showing that the actual fender and the objects in the Apollo images you posted  look nothing like each other.
« Last Edit: December 19, 2018, 02:41:59 AM by onebigmonkey »

Offline Allan F

  • Saturn
  • ****
  • Posts: 1029
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #253 on: December 19, 2018, 06:03:13 AM »
Hi Alan F

Don't say I don't help you guys. Here is some bedtime reading for you. I have a lot more places to get docs. Happy Reading.

https://www.ibiblio.org/apollo/Documents/

Obviously, you can't answer the question. That means YOU didn't find it. Somebody spoonfed it to you. What was that persons motivation? To make you look ... silly?
Well, it is like this: The truth doesn't need insults. Insults are the refuge of a darkened mind, a mind that refuses to open and see. Foul language can't outcompete knowledge. And knowledge is the result of education. Education is the result of the wish to know more, not less.

Offline Jason Thompson

  • Uranus
  • ****
  • Posts: 1601
Re: Apollo 11 Lunar Lander Pre-Launch
« Reply #254 on: December 19, 2018, 06:47:34 AM »
Like each of your vaguely hinted at claims, there is no substance here.

Actually there's quite a bit of substance, but none of it supports his claim. It takes either huge chutzpah or simple incompetence to claim something supports an argument when that something, besides all the rest that has been pointed out already, includes a mathematical equation that can be applied.

So, go on, jr, show us you understand the subject by using that equation. It allows you to figure out under exactly what conditions a positive feedback loop leading to uncontrollable spinning would arise with automatic control systems in the event of a failure of a jet. Apply it to the undocked LM. You know the LM dimensions so you can easily calculate a possible range of the values D1 and D2 and see what effect this has on M+X.
« Last Edit: December 19, 2018, 07:29:11 AM by Jason Thompson »
"There's this idea that everyone's opinion is equally valid. My arse! Bloke who was a professor of dentistry for forty years does NOT have a debate with some eejit who removes his teeth with string and a door!"  - Dara O'Briain